Audio

If you are on this page that means you are looking for audio help. Below is a step-by-step guide to getting the system up and running. Below that you will find helpful links to manuals and links to more in-depth information.

System Startup

  1. Go to backstage amp room

    1. Verify breakers 7 & 9 are turned on in the panel above the toolbox.

    2. Verify red power switch in the top right of the rack is turned on.

    3. Grab any microphones or iem body packs needed.

  2. Go to the stage

    1. Place microphones and iem body packs where needed.

  3. Go to the booth

    1. Turn console on via the power switch in the back left (from the viewpoint of standing at the console).

    2. On the left side of console screen look for "utility" click the "memory" tab, then select the show you need and hit "recall".

  4. For console operation please consult the user manual below.

System Shut Down

  1. To shut console down, on the left side of the screen hit "utility", then touch the "status" tab, finally touch "power down". Once the screen says you are good to shut console off, flip the switch on the back left (from the viewpoint of standing at the console).

  2. Go to stage and collect all wireless microphones and iem bodypacks.

  3. Go to backstage amp room and place all wireless mics and iem bodypacks in chargers.


As we come across any helpful links for running audio they will get posted to the right.

System Routing

  • In console "I/O" tab system routing can be found.

  • I/O Port 1 = Allen and Heath stage box inputs and outputs. There are three boxes located on the stage and one output only box in the back room for IEM's.

  • I/O Port 2 = Dante audio network. This is how the broadcast X32 receives audio. Patching is made across I/O port 1 and I/O port 2 in the "Tie Lines" tab.

  • I/O Port 2 to the X32 is channels 1 to 32